Pipo S1 Pro hard brick

Discussion in 'Firmware, ROMs & Recovery' started by Milan As, Jan 21, 2015.

Remove Advertisements
  1. Milan As

    Milan As Member

    Posts:
    1
    Likes Received:
    0
    Trophy Points:
    0
    Tablet:
    pipo s1 pro
    Phone:
    coolpad f1
    Hy guys. My Pipo got hard bricked so i did a little research how to unbrick it. So tablet did not respond when i push the power button or any other button. My comp didnt recognise the tablet when I plugged it into computer. I opened it up and short pinned NAND chip. Then computer detect it but didn't install the drivers for it so i installed it manually. Computer detect it as a Rockusb Device. In RKBatchTool i have a blue box, I try to use switch button but got an error. In RKAndroidTool v.1.37 on the bottom sez "Found Rkandroid MaskRom mode" but when i press "EraseIDB" after few second message pops up "Erasing IDB failed".
    Can you guys help me because i'm out of ideas...
     

    Attached Files:

  2. ATAB

    ATAB Staff Member Global Moderator

    Posts:
    1,475
    Likes Received:
    47
    Trophy Points:
    67
    Location:
    Pott in Germany
    Tablet:
    Odys Genio 7"
    Phone:
    Samsung S2
    Any luck with 'unbricking' the tablet !?
    It is a RK3066 device, correct ?

    ATAB
     
Remove Advertisements