Progress on Kernel Source for RK3066

Discussion in 'N101 Firmware, ROMs & Recovery' started by duck123, Oct 20, 2012.

Remove Advertisements
  1. duck123

    duck123 Member

    Posts:
    7
    Likes Received:
    2
    Trophy Points:
    2
    darkonen and ilyakos like this.
  2. ATAB

    ATAB Staff Member Global Moderator

    Posts:
    1,487
    Likes Received:
    47
    Trophy Points:
    67
    Location:
    Pott in Germany
    Tablet:
    Odys Genio 7"
    Phone:
    Samsung S2
    Cool find...
     
  3. JohnMorris

    JohnMorris Member

    Posts:
    7
    Likes Received:
    6
    Trophy Points:
    2
    Tablet:
    N101-II
    I compiled up the Edison sources for my N101-2 just for giggles. After a bit of .config hacking, it sort of works. i.e. Basic functionality, LCD, touch, wireless, USB guest etc works.

    But the list of stuff that (predictably) doesn't work is long. including:
    - Charging display
    - USB OTG power
    - Speaker amp enable
    - Bluetooth (power up issue I suspect)
    - G sensor (again, power up issue)
    - Light sensor
    - Touchscreen is a bit wobbly (old driver, or i2c clocking issue)
    - Camera (again, probably a power up issue)

    Also, the sources are ICS only. JB won't run on it.

    Needs someone with lots of time on their hands to go through each of the above and work out which GPIOs go to what device on the board. Probably would take reverse engineering a working kernel.

    Edit:

    I'm probably not going to continue on with this, so here is my .config, and the diffs for a couple of small changes to get it to compile, if anyone wants to carry the torch...

    http://www.fileden.com/files/2008/1/5/1680931/n1012edisonconfig.tar.gz
     
    xapienz and paira like this.
  4. pangccw

    pangccw Member

    Posts:
    2
    Likes Received:
    0
    Trophy Points:
    0
    Tablet:
    yuandao N101
    good job
     
Remove Advertisements